Search
Archives
RGB Strip Lights per foot
$1.00
70 in stock (can be backordered)
12 V strip lights perfect for 3 cell power
Price per foot so mutiple orders will be shipped as one length as in you order 6 you will get a 6ft peice.
Best to use a 3s Balance connector your able to use 1 color or and combination of Red Green and lue
You must be logged in to post a review.
You may also like…
Related products
-
EZBUILD
EZBuild Cub 40 On Hold Until June
$59.00Read moreEZ Build Cub 40 Instructions Cub 40 Kit 40″ wingspan made from model airplane foam. The EZ Build Cub 40 is designed to be flown by novice to expert. It is strong and lightweight and, depending on the power set up, can do many 3D maneuvers. It can be set up with flaperons or spoilerons. …
-
EZBUILD
45″ Long Flying Surfboard
Rated 5.00 out of 5$25.00Add to cartEZ Build Surfboard concept by Mark Carew
Specs:
● Length 45”
● Width 14”
● Approx wt 14 oz
Parts:
Foam:
● 1- surfboard
● 1- elevator
● 2- board doubles
● 1-center keel
● 1-rudder
● 2-outside keels
● 1-Character option
Plywood:
● 1-two piece motor mount
● 1-battery mount
Misc:
● 2-horn/linkage stopper, right and left
● 1-10” elevator rod with Z bend
● 1-12” rudder rod with Z bend
● 1-5” double sided velcro
Power pack (optional, note: uses 500 mAh/3 cell battery))
● 1-Blue Wonder motor, 1700 kv
● 1- 10 Amp ESC
● 1- 8” x 4” prop
● 2- 9 gram servos
Assembly (use hot glue or Foamtac):
● Cut hinge bevels on surfboard/elevator and keel/rudder
● Use packing tape to make the hinges
● Glue board doubles on top
● Glue 3 keels to the bottom
● Glue battery velcro in the plywood battery mount
● Glue the battery mount to the bottom, front of the surfboard at the cutout
● Glue the linkage horns to the elevator and rudder
● Glue the elevator and rudder servos
● Install the rods
● Mount motor/ESC/receiver
● Slide in your surfer character
Throws: Elevator 1” up, ½” down, Rudder =/- 1”, CG is 14” from nose
Reviews
There are no reviews yet.