EZBUILD
Adhesives
Batteries
Duck Buggy
Electronics
EZbuilRC Planes
Fenix Planes
Hardware
Motors
Props
EZStick40 in Stock
$59.00
40″ wingspan EZ Stick from EZBuild RC
https://ezbuildrc.com/wp-content/uploads/2019/05/EZ-Build-Stik-40.pdf
Out of stock
This Kit is totally painted and partially assembled. Assembly is less than 2 hours.
It is a quick beautiful looker and stable aerobatic flyer.
40″ wingspan
The Manual is in the manual tab.
Includes :
Wing and Tail Carbon Installed
Plywood LG braces installed
Carbon Installed
Carbon / Wire Landing Gear
Wheels
Motor mount for most X mount style motor
Decals installed
Floats will be available
You must be logged in to post a review.
Related products
-
EZBUILD
45″ Long Flying Surfboard
$25.00
Add to cartEZ Build Surfboard concept by Mark Carew
Specs:
● Length 45”
● Width 14”
● Approx wt 14 oz
Parts:
Foam:
● 1- surfboard
● 1- elevator
● 2- board doubles
● 1-center keel
● 1-rudder
● 2-outside keels
● 1-Character option
Plywood:
● 1-two piece motor mount
● 1-battery mount
Misc:
● 2-horn/linkage stopper, right and left
● 1-10” elevator rod with Z bend
● 1-12” rudder rod with Z bend
● 1-5” double sided velcro
Power pack (optional, note: uses 500 mAh/3 cell battery))
● 1-Blue Wonder motor, 1700 kv
● 1- 10 Amp ESC
● 1- 8” x 4” prop
● 2- 9 gram servos
Assembly (use hot glue or Foamtac):
● Cut hinge bevels on surfboard/elevator and keel/rudder
● Use packing tape to make the hinges
● Glue board doubles on top
● Glue 3 keels to the bottom
● Glue battery velcro in the plywood battery mount
● Glue the battery mount to the bottom, front of the surfboard at the cutout
● Glue the linkage horns to the elevator and rudder
● Glue the elevator and rudder servos
● Install the rods
● Mount motor/ESC/receiver
● Slide in your surfer character
Throws: Elevator 1” up, ½” down, Rudder =/- 1”, CG is 14” from nose
Reviews
There are no reviews yet.