EZBUILD
Adhesives
Batteries
Duck Buggy
Electronics
EZbuilRC Planes
Hardware
Motors
Props
1 Pair 3×2 props with 1mm hole
$2.50
20 in stock
We use these on the 1306 motor usually drill a 1mm starting hole and press on
You must be logged in to post a review.
Related products
-
EZBUILD
EZ Lazer Kit
$29.00
Read moreThis plane has always been a Parkflyer and a great night-flyer.Wow !This kit is an easy build. Good for flying in smaller areas. Responsive and an excellent flyer!Made from stiff White-Core Hobby Foam (I Like It).
Comes Partially AssembledSpecs:Wing Span 24 inchesLength 21 inchesThe EZ Lazer has Elevon Control this is available on all newer radios
Comes with:Laser Cut Foam Parts and Laser Cut Plywood, precision fit !1 motor mount2 pushrods2 Linkage Stoppers2 control horns installed2 pushrod GuidesVelcroSuggested Electronics-(Not Included)1- 2730 blue wonder1- 15 amp ESC2- 9g Budget Servos1- 8×4 Props withe the 1700 KV motorRecommended Lipo:1- 450 TO 850 mAh 3S battery (not included)Glue ..Hot GlueLazer foam Kit includes:8 Laser cut foam pieces that fit perfectly all you need to do is add the rudders and electronics
2 Control horns installes
2 Pushrods
2 Linkage stoppers
1 Plywood motor mount installedParts you will need to Fly this plane
Motor, 2)Servos, Receiver 4 or 6 channel (Only uses 3)
Transmitter(you need an Elevon Mixing Transmitter) -
EZBUILD
45″ Long Flying Surfboard
$25.00
Add to cartEZ Build Surfboard concept by Mark Carew
Specs:
● Length 45”
● Width 14”
● Approx wt 14 oz
Parts:
Foam:
● 1- surfboard
● 1- elevator
● 2- board doubles
● 1-center keel
● 1-rudder
● 2-outside keels
● 1-Character option
Plywood:
● 1-two piece motor mount
● 1-battery mount
Misc:
● 2-horn/linkage stopper, right and left
● 1-10” elevator rod with Z bend
● 1-12” rudder rod with Z bend
● 1-5” double sided velcro
Power pack (optional, note: uses 500 mAh/3 cell battery))
● 1-Blue Wonder motor, 1700 kv
● 1- 10 Amp ESC
● 1- 8” x 4” prop
● 2- 9 gram servos
Assembly (use hot glue or Foamtac):
● Cut hinge bevels on surfboard/elevator and keel/rudder
● Use packing tape to make the hinges
● Glue board doubles on top
● Glue 3 keels to the bottom
● Glue battery velcro in the plywood battery mount
● Glue the battery mount to the bottom, front of the surfboard at the cutout
● Glue the linkage horns to the elevator and rudder
● Glue the elevator and rudder servos
● Install the rods
● Mount motor/ESC/receiver
● Slide in your surfer character
Throws: Elevator 1” up, ½” down, Rudder =/- 1”, CG is 14” from nose
Reviews
There are no reviews yet.