On the Vortex 40 what do you recommend as the amount of control service movements? In the kite I received there was no hex key for the linkage stoppers what size do I need?
I like the kite!
Bob Radvansky
The blog that I received was to my old Email address please send to rradvansky9@gmail.com
There’s a lot motor parts on the 40” Vortex is it different than what you show in this video
Yes we made a few upgrades we need a new video, coming soon
there is a nother video on YouTube
it is the same assembly as the Emax motor I put up on Youtube
there is a nother video on YouTube
https://www.youtube.com/embed/sCTwHmpCQkc
On the Vortex 40 what do you recommend as the amount of control service movements? In the kite I received there was no hex key for the linkage stoppers what size do I need?
I like the kite!
Bob Radvansky
The blog that I received was to my old Email address please send to rradvansky9@gmail.com
Bob the control surfaces should be 1/2″ max at the start
Hex key is 1.5 mm